Post

Gyproc Plaster Bonding Solution - Gyproc BOND-it 

Gyproc BOND-it is a bonding agent for Gypsum plaster & Sand cement plaster that enables preparation of Ceiling and wall surfaces (especially RCC surfaces) within 24 hours. Gyproc BOND-it eliminates risk of debonding gypsum plaster or sand cement plaster from ceiling (RCC surface) due to its low suction background and continuously under pressure of gravity. It enables dual benefits of mechanical and chemical bonding, and completely eliminates the labour intensive hacking process and the risk of plaster de-bonding.

Packaging

Bucket Size:

20kg

10kg

5kg

1kg
  • Gyproc BOND-it increases pull out strength by 5 times against conventional hacking process.
  • New technology like aluminium formwork shuttering needs products like Gyproc BOND-it to provide adhesion of Gypsum plastering.

Features and Benefits

  • Dual Bonding Chemical and Mechanical Key
  • Single Coat brush application
  • No Tackiness required
  • Green Colour
  • 2X more strength
  • 10X faster Application
  • Easy Supervision

Technical Parameters of Bond-it

Technical Parameters Range/Value
Drying time 1 Day
Open time for plastering 2 to 10 Days
Coverage 5 m2/kg
Ambient temp requirement 5 to 45 °C
Pull out strength (failure load) >1.01 MPa

Areas of Application

  • RCC Columns
  • Beams
  • Concrete Surfaces
  • Slabs
  • Sheer Walls

Application Procedure

Background Preparation:

Surface on which BOND-it application to be done should be clean, dry and free from mold oil or any other agents. Any faults in the structure, particularly those which may lead to moisture penetration, must be rectified. Just before application of BOND-it, prewetting must be done with the help of a brush/roller.

Mixing:

Mix material properly with clean rod to properly distribute solid particles in the solution.

Application:

Use good quality paint brush. The brush should be cleaned with enough water immediately after use. Apply with even distribution of fine aggregates over the surface. Allow it to dry thoroughly for around 24 hours.

Application Instructions

Three Easy Steps to use Gyproc BOND-it,
❄ STEP 1 : Open and stir the contents
❄ STEP 2 : Apply with a paint brush
❄ STEP 3 : Dry for 24 hrs. Surface ready for plastering