Saint Gobain Weber Tile Adhesive - Webertec NSG 2
Webertec NSG 2 is a specially developed, triple consistency shrinkage-compensated grout, for anchoring / precision grouting, as well as for non-structural concrete repairs. Webertec NSG 2 can be used in fluid, pourable and trowellable consistency for gap thickness upto 100 mm, complying to ASTM C 1107. Webertec NSG 2 can be used in trowellable as well as pourable consistency as a repair mortar, complying to R2 standards of EN 1504 – 3
Packaging
Bag Size:
- We can use on Wall & Floor.
Advantages
- high strength for anchoring and precision grouting
- High early strength and high ultimate strength ensures long life of grout and repaired substrate
- High bond strength
- Shrinkage compensation in the plastic state, through gaseous expansion
- HIGH COMPRESSIVE STRENGTH
- FLOWABLE
- NON-SHRINK GROUT
- POURABLE APPLICATION
- STIRRER BLADE MIXING
Features and Benefits
- Chloride-free – Develops high initial strength without the use of chlorides.
- Shrinkage compensation in the plastic state, through gaseous expansion.
- High early strength and high ultimate strength ensure long life of grout and repaired substrate.
- No bleeding or segregation.
- Prepacked with graded aggregates, to eliminate job site variations.
- Iron-free – does not cause staining.
- High bond strength with the existing concrete.
Things to Consider
❄ Never exceed the maximum water ratio, as prescribed.
❄ For filling gaps more than 100 mm thick, additional aggregates would need to be added.
❄ Make sure the surfaces are clean, to prevent debonding.
❄ Ensure adequate curing is done.
❄ Ensure continuous pouring to prevent the formation of cold joints.
❄ Ensure the grout is uniformly compacted.
❄ Levelling shims should have rounded edges, to prevent stress accumulation.
❄ Mix enough quantity of grout, so that there is no shortage in between placing the grout.
❄ Meant for non-structural repair only. Not to be used for structural repairs.